My Blog on my Bastion print.
Pretty much printed out all the whole engine but wating on the all terrain options before assembly then painting. While it suggested you can swap out, it is not tight enough and feels like it would need glue to keep the under carriage in place.
Any ETA on the wheeled option Cassidy?
The Engine is a beast. Looking forward to getting it painted and weathered for my Necromunda campaign.
I had two failed prints on the main body of the Bastion. It was lifting on one corner but just changed the initial layer to 0.2mm from 0.15 mm and it adhered to the textured plate just fine.
I have been printing out the troop car. The blast shutters DB1 DB2 DB3 DB4 are different to the instructions. The shutters appear to have a handle or clip in the instructions. The printed shutters are flat. I have not printed all parts to assemble so do not know if there is an issue or just a discrepancy.
Also any ETA on the off track stretch goal?