My Blog on my Bastion print.
Pretty much printed out all the whole engine but wating on the all terrain options before assembly then painting. While it suggested you can swap out, it is not tight enough and feels like it would need glue to keep the under carriage in place.
Any ETA on the wheeled option Cassidy?
The Engine is a beast. Looking forward to getting it painted and weathered for my Necromunda campaign.
I had two failed prints on the main body of the Bastion. It was lifting on one corner but just changed the initial layer to 0.2mm from 0.15 mm and it adhered to the textured plate just fine.
Hi Jim! This is looking good! The small tires were the right choice for this setup! Thanks for the notes about the instructions I'll investigate the discrepancy and make those changes in the next update. I'm sorry about the Longstriker. I've printed it successfully and can confirm others have as well, but I'm all for strengthening and improving it where necessary. If it happens again let me know and I'll make some changes. Do you have a paint scheme in mind?